™
p^
FLYWHEEL
Removal
FLYWHEEUPILOT
BEARING
PILOT BEARING
Removal
1.
Disconnect negative battery cable and raise
vehicle on hoist.
2.
Remove transmission as outlined in
transmission section.
3. Remove clutch as outlined in clutch section.
4.
Mark flywheel and crankshaft for indexing
purposes.
5. Remove flywheel attaching bolts and flywheel.
Installation
1.
Reverse removal procedure.
Note:
Flywheel bolts must be replaced after
each
dismantling. Apply Loctite
601
or equivalent on
bolt threads.
1.
Disconnect negative battery cable and raise
vehicle on hoist.
2.
Remove transmission as outlined in
transmission section.
3. Remove clutch as outlined in clutch section.
4.
Remove pilot bearing using tool J 23907.
5. Apply Loctite 601 or equivalent to outside of
pilot bearing and install using suitable drift.
Installation
1.
Reverse removal procedure.
To Next Page
Loading...
