fF&H
BLEEDING SYSTEM
BLEEDING AND FLUSHING
FLUSHING SYSTEM
1.
Top up clutch fluid reservoir with specified
fluid.
Note:
Ensure that reservoir fluid level is maintained
throughout the bleeding procedure.
2.
Connect one end of a hose to the bleedscrew
and place the other end in a container.
3. Raise vehicle and open bleedscrew on clutch
slave cylinder enough to allow the fluid to be
pumped out.
4.
Depress the clutch pedal through the full
stroke,
followed by three short, rapid strokes.
5. Close the bleedscrew before releasing the
pedal on the last stroke. Release the pedal and
allow it to return rapidly.
6. Open bleedscrew and repeat operation 4 and 5
until all the air is evacuated.
7. Remove bleed hose and top up reservoir to
bring the level to within 10 mm (0.394 in.) of
the bottom of the filler neck.
It is recommended that the entire hydraulic system
be thoroughly flushed with clean brake fluid
whenever new parts are installed in the hydraulic
system.
Flushing is also recommended if there is any doubt
as to the grade of fluid or if there is any trace of
contamination.
1.
Remove fluid from clutch reservoir.
2.
Top up reservoir with new fluid and perform
bleeding operation. See "Bleeding Hydraulic
System"
procedures.
3. Continue to bleed until all of old fluid has been
flushed from system.
0h
To Next Page
Loading...
