(TVS*)
L
I
SPECIFICATIONS
GEAR RATIOS
1st. 3.364 4th.
2nd.
2.059 5th.
3rd.
1.381 Rev.
1.057
0.8205
3.1818
FINAL DRIVE RATIO
3:44:1
LUBRICANT
Capacity: 3.7 litres (7.82 pints)
Viscosity: Below
-10°C
(-3°F)
SAE 75
Above
-10°C
(-3°F)
SAE 80
Classification: Must meet spec.
MIL—L—2105C
or
API-GLS
*W|
DIFFERENTIAL
Backlash:
Nonadjustable
Carrier Bearing Preload:
New Bearing 10-30
Nm
(2.7 LB)
Used Bearings Must turn
free
without
any play.
TORQUE SPECIFICATIONS
Transmission mount brackets to rear
cover—
25 Newton Metres (18
FT/LB)
Clutch housing to engine shield
—
20 Newton Metres (14
FT/LB)
Starter motor to clutch housing
—
27 Newton Metres (19
FT/LB)
Flywheel protection shields to clutch housing
—
20 Newton Metres (14
FT/LB)
Inner driveshaft to flange
Shift cable mount brackets to rear cover
—
25 Newton Metres (18
FT/LB)
Transmission drain and fill plugs
—
19 Newton Metres (13 FT LB)
Rear cover to case—
20 Newton Metres (14.6
FT/LB)
Half-casing attaching bolts:
8 mm diameter 30 NM (22.5 FT LB)
10 mm diameter 45-55 NM (34-41 FT LB)
Clutch housing to case—
45-55 NM (34-41 FT/LB)
Differential ring gear to
carrier—
120-140 NM (90-105 FT/LB)
Primary shaft nut
—
120-150 NM (90-112.5 FT'LB)
Secondary shaft nut—
120-150 NM (90-112.5 FT/LB)
Bearing retaining plate to
case —
45-55 NM (34-41 FT/LB)
Reverse shift fork to case—
12-14 NM (22-30 FT'LB)
SPECIAL TOOLS
J28869 Spring Compressor
J28866 Slide Bearing Cap Wrench
J33400 Seal Installer
J23907 Pilot Bearing Installer
M*J
FFr^ff|
To Next Page
Loading...
