Front Suspension
HUB BEARING - RIGHT OR LEFT
REMOVAL
1.
Raise car on hoist.
2.
Remove tyre and wheel assembly.
6. Remove hub nut and "D" washer.
7. Remove hub and brake disc assembly.
3. When working on left side, disconnect
speedometer cable.
4.
Remove both brake caliper mounting bolts and
position caliper assembly out of the way.
Caliper must not be suspended by brake hose.
Fig. 7
5. When working on
left
„side,
remove
speedometer drive cap fronivcentre of hub.
Fig. 8
8. Remove snap
ring,
retaining hub bearing to
hub assembly. Remove hub bearing by
pressing.
9. Press new hub bearing into hub assembly.
Fig. 9
10.
Position and secure hub bearing snap
ring.
INSTALLATION
Reverse removal procedure starting with Step 7
and torque fasteners to specification.
To Next Page
Loading...
