Delorean DMC - Page 319

Electrical System and Instruments
M:14:03
pwj
fW\
nm?i
ffWKTi
->
F^*i
ITl*fl)
TURN SIGNAUHAZARD WARNING
FLASHER UNIT
REMOVING - REFITTING - Fig. 60
Removing
• Locate flasher unit (2) under dash pad to L.H.S.
of steering column.
• Pull unit out of wiring socket.
Refitting
REVERSE REMOVAL PROCEDURE.
DOOR LOGIC BUZZER BOX
REMOVING - REFITTING - Fig. 60
Removing
• Locate logic buzzer box (1) beside flasher unit.
• Remove one posidrive screw (3).
• Disconnect harness plug (4).
• Withdraw logic box.
Refitting
REVERSE REMOVAL PROCEDURE.
WIPER DELAY CONTROL BOX
REMOVING - REFITTING - Fig. 60
SEE WIPER SECTION M:09:03.
HANDBRAKE SWITCH
REMOVING - REFITTING
Removing
• Remove carpet handbrake cover.
• Slide rubber sheath from handbrake lever.
• Apply handbrake.
• Using a 90° angle posidrive screwdriver remove
two posidrive securing screws.
• Disconnect wiring connection.
• Remove switch.
Refitting
REVERSE REMOVAL PROCEDURE.
SEAT BELT SWITCH
• The seat belt switch is incorporated within the
seat belt anchor and must be replaced as an
anchor unit.