Delorean DMC - Page 320

Electrical System and Instruments
ENGINE COOLING
FAN SWITCH (OTTERSTAT SWITCH)
REMOVING - REFITTING - Fig. 61
CAUTION: This operation must be carried out
with the engine cold.
Note:
The engine cooling fan switch is located in the
engine bay on the lower L.H. side of the engine, in
the engine to radiator water pipe.
J
Removing
• Partly drain cooling system.
• Disconnect wiring (1) connection to switch (2).
• Remove spring clip (3) securing switch (2) in
pipe (4).
• Remove switch (2).
• Remove and discard grommet (5).
Refitting
• Fit new grommet (5) and refit spring clip (3).
• Reconnect wiring terminals (1).
• Top up cooling system to correct level with
recommended mixture.
FUEL TANK SENDER UNIT
REMOVAL - REFITTING - Fig. 62
Removal
• Remove spare wheel from luggage compart-
ment.
• Remove carpet.
• Remove screws (1) holding panel (2) at rear of
spare wheel well and remove panel (2).
• Disconnect electrical connector (3) to sender
(4).
• Unscrew sender retaining cap (5).
• Withdraw sender unit (4).
Refitting
REVERSE REMOVAL PROCEDURE.