(3) When completely cured, drill a one inch
diameter hole in the area to be refilled with
foam on a horizontal face and refill with
Polyurethane two part mix foam.
(4) When the foam has completely cured, remove
any excess foam from the area above the hole
and finally seal with three (3)
laminants
of
chopped mat and resin, then sand to contour.
CAUTION:
The Styrene fumes given off due to
catalytic action are hazardous to health and also
highly flammable. Therefore extreme caution
should be taken when carrying out any G.R.P.
repair.
Goggles and protective clothing should be used at
all times. In the event of Resin or catalyst entering
the eyes, quick medical attention is essential.
G.R.P. repairs must be carried out in a well
ventilated area. The resins and catalysts must be
stored in a cool area.
!
i-.-vj
0 1
WBM
11''
j
(••••••
1
To Next Page
Loading...
