Connection Systems
Delphi Connections Systems Page 8 of 11 01/02/2001
Note: Assembly Instructions are provided for reference only, and are intended for use by skilled assembly technicians.
Personal injury, failure of the system to work as intended, and damage to the product may result from failure to follow the
assembly and disassembly techniques and/or use of tools other than those described. Always follow Assembly
Instructions thoroughly, and please contact Delphi Connection Systems for further assistance.
ASSEMBLY INSTRUCTIONS
MICRO 64 CONNECTOR ASSEMBLY
APPLY HARNESS COVERINGS PER PRODUCT PRINT.
STEP 5:
STEP 4:
COMPLETED
STEP 4
APPLY SECONDARY LOCK: AFTER
PLUGGING ALL THE LEADS INTO THE
CONNECTOR BODY, START SECONDARY
LOCK INTO CONNECTOR AND PUSH TO
INSERT. ORIENTATION IS REQUIRED.
USE TOOL # 12152222 TO FULLY SEAT THE
SECONDARY LOCK TO A HARD STOP
POSITION.
CAUTION: THE SECONDARY LOCK MUST
BE FULLY SEATED,
CONNECTOR BODY FROM ITS HOLDER OR
To Next Page
Loading...