Do you have a question about the Delta OHM HD35 Series and is the answer not in the manual?
Data Storage | Internal memory |
---|---|
Communication Interface | USB |
Relative Humidity Range | 0 to 100%RH |
Relative Humidity Accuracy | ±1.5%RH |
Measurement Parameters | Temperature, Relative Humidity |
Measurement Range | Humidity: 0 to 100%RH |
Accuracy | Relative Humidity: ±1.5% RH |
Resolution | Temperature: 0.1°C, Relative Humidity: 0.1% RH |
Power Supply | Battery |
Temperature Range | -40 to 80°C |
Sampling Interval | 1 second to 24 hours |
Protection Rating | IP67 (with connector protection) |
Protection Degree | IP67 (with connector protection) |
Describes the base unit's role as an interface between loggers and PC.
Describes remote devices that acquire and store measurements.
Procedure for adding devices to the wireless network.
Setting system operation parameters like logging intervals and alarm thresholds.
Explains the physical components and LEDs of the base unit.
Procedure for connecting the base unit to a PC via USB.
Explains the physical components and LEDs of the repeater.
Explains the components and LEDs of indoor data loggers.
Navigating the data logger menu for configuration.
Procedure for calibrating the CO sensor to 0 ppm.
Procedure for calibrating the CO2 sensor.
Explains the components and LEDs of waterproof data loggers.
Connecting and disconnecting waterproof data loggers to the network.
Explains the components and LEDs of the alarm device.
Details on combined probes for temperature and relative humidity.
Information on ordering base units, repeaters, and alarm modules.
Product compliance with EMC and low voltage directives.