Delta-q Milk QOOL - Machine Alerts and Error Indicators; Low Water Level Alert

87
MILKQOOL
ALERTS AND ALARMS
Lack of water
The indicator lights of the espresso and the tea buttons blink (red colour)
(see Fig. 35), indicating that the water tank does not contain enough
water for the machine to work correctly. You must resupply the tank with
water, if the middle of an extraction lift the lever again at the end of the
extraction process to release the capsule into the used capsule tank.
Press one of the control panel buttons.
The machine returns to “Ready to use” mode (see Fig. 7).
Press the tea extraction button to start a purge.
If, after carrying out this operation, the luminous alert remains unchanged,
please turn the equipment o, wait for 2 minutes and turn it back on
again after 2 minutes.
If the problem persists, contact Customer Service and Support
(00 800 20 50 20 50 -
toll free).
Used capsules tank full/ Containers out
The four extraction buttons blink (red colour) (see Fig. 36), indicating
that the used capsules tank is full, thus not allowing the machine to work
correctly. The tank must be emptied and returned to the correct and
specified position.
The alert disappears after de machine detects that the used capsule tank
is correctly positioned.
If, after carrying out this operation the luminous alert remains unchanged,
please turn the equipment o, wait for 2 minutes and turn it back on again.
If the problem persists, contact Customer Service and Support
(00 800 20 50 20 50 -
toll free).
Temperature sensor (NTC malfunction)
The four extraction buttons turn red (see Fig. 37). Please turn the
equipment o, wait for 2 minutes and turn it back on again.
If the problem persists, contact Customer Service and Support
(00 800 20 50 20 50 -
toll free).
Fig. 35: Luminous alert that there is a
lack of water in the water tank.
Fig. 36: Luminous alert that used
capsules tank is full.
Fig. 37: Luminous alert for NTC
malfunction alarm.
A.
B.
C.
D.
A.
B.
C. D.
A.
B.
C.
D.