MILK-BASED BEVERAGE
— 11 —
EN
PROGRAMMING THE COFFEE/GALÃO - LATTE AMOUNT
Adjust the selector to the Galão - Latte position.
Button D and selector’s side light is green.
Raise the lever to its full extent and insert a Delta Q coee capsule
in the capsule housing hole, in accordance with the housing
silhouette. Completely lower the lever.
Place a glass of Galão - Latte under the extraction nozzle.
Hold the button D more than 3 seconds, and the button A, B and C
blink.
Press the button D again, thus beginning the coee extraction.
When the coee reaches the desired amount, press the button D.
The machine memorises this coee volume and will start extracting
it until a new programme is set.
Afterwards, the machine pre-heats (approximately 25 seconds).
When it reaches the right temperature, the milk extraction begins
and when the milk reaches the desired amount, press the button D
again. And it return to Ready to Use Mode.
The machine memorises this milk volume and will start extracting it
until a new programme is set.
When in Ready to Use Mode, the milk tank with enough milk is connected to the milk system.
PROGRAMMING THE COFFEE/CAPPUCCINO AMOUNT
Adjust the selector to the Cappuccino position.
Button D and selector’s side light is green.
The next steps are the same as for predening a Galão - Latte.
The dierence is the cappuccino starting as follows: rst the milk
foam (the machine pre-heats for approximately 25 seconds. when it
reaches the right temperature, the milk foam extraction begins) and
then the coee.
When in Ready to Use Mode, the milk tank with enough milk is connected to the milk system.
If no button is pressed for 1 minute, the machine will return to Ready to Use Mode and will
memorise the last volume set.
If button D is not pressed to stop the extraction process, the machine will automatically
stop when it reaches approximately 220cc.
If button D is not pressed to stop the extraction process, the machine will automatically
stop when it reaches approximately 220cc.
B
A
C
B
A
C