Delta GBR80MHLED - User Manual

MODELS:
GBR80HLED,
GBR
80
LED,
GBR80MHLED
,
GBR100HLED
,
GBR
100
LED
INSTALLATION AND OPERATING INSTRUCTIONS
VENTILATION FAN /DIMMABLE LED LIGHT
READ AND SAVE THESE INSTRUCTIONS
GENERAL SAFETY INFORMATION
1. Make sure that the electric service supply voltage is AC 120V,
60Hz.
2. Follow all local electrical and safety codes, as well as the Nation
Electrical Code (NEC) and the Occupation Safety and Healthy Act
(OSH Act).
3. Always disconnect the power source before working on or near
the ventilating fan, motor or junction box.
4. Protect the power cord from sharp edges, oil, grease, hot
surfaces, chemicals or other objects.
5. Do not kink the power cord.
6. Do not install the unit where ducts are configured as shown in
Fig. A.
7. Provide suction parts with proper ventilation.
8. This unit is UL listed for use over a bathtub or shower when
installed in a GFCI protected branch circuit.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer.
2. Before servicing or cleaning unit, switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction.
4. Sufficient air is needed for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment to
prevent back drafting. Follow the heating equipment
manufacturer’s guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society of Heating, Refrigerating and Air-
Conditioning Engineers (ASHRAE), and the local code authorities.
5. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. If this unit is to be installed over a tub or shower, it must be
marked as appropriate for the application and be connected to a
GFCI (Ground Fault Circuit Interrupter) --- protected branch
circuit.
8. Do not use this unit with any other solid-state control devices.
Solid-state control devices may cause harmonic distortion,
which can cause a motor humming noise. (Avertissement: ne
convient pas à des régulateurs de vitesse à semi-conducteurs).
9. NEVER place a switch where it can be reached from a tub or
shower.
10. Not to be installed in a ceiling thermally insulated to a value
greater than R50. (This is required for installation in Canada
only).
Turning angle too large Duct shrink
Too many elbows Elbow near the body
Body
Fig. A
CAUTION
1. For General Ventilating Use Only. Do Not Use To Exhaust
Hazardous Or Explosive Materials And Vapors.
2. Not for use in cooking areas. (Fig. B)
3. This product must properly connect to the grounding conductor
of the supply circuit.
4. To reduce the risk of injury to persons, install the fan at least 8.2
feet (2.5m) above the floor.
4
5
Cooking area
4
5
Do not install above or
inside this area
Cooking
Equipment
floor
Fig. B
Page 1.

Summary

General Safety Information

Electrical Safety and Precautions

Covers electrical supply, codes, power disconnection, cord care, and GFCI for safe operation.

Warning

Reducing Risks of Fire, Shock, or Injury

Provides critical warnings on proper use, servicing, installation, airflow, wiring, and GFCI protection.

Caution

Operational and Installation Cautions

Highlights usage restrictions, grounding requirements, and installation height to prevent hazards.

Supplied Accessories

Accessory List

Lists all components included with the ventilation fan unit for installation.

Installations

Mounting Housing with Flange

Details steps for mounting the fan housing using its flange and screws to joists.

Using Suspension Brackets

Explains how to use suspension brackets for positioning and securing the fan between joists.

Duct Connection

Duct Installation Guidelines

Provides instructions for securely connecting and installing ductwork for optimal airflow.

Connect Wiring

Wiring Diagrams and Safety Codes

Details wiring instructions following safety codes and provides diagrams for different models.

Grille Attachment & Test Run

Grille Installation and Initial Test

Guides on attaching the grille and performing an initial test run for proper function.

Operation

Fan Operation Modes

Explains operation for single-speed and humidity-controlled models, including LED indicators.

Dimensions

Product Dimensions

Provides detailed measurements of the ventilation fan unit for installation planning.

Maintenance

Cleaning and Care Instructions

Details safety warnings and procedures for cleaning the fan and its components.

Specifications

Fan Specifications

Lists technical data for fan models including voltage, power, airflow, and weight.

LED Light Specifications

Details specifications for the LED light, including power, lumens, color temperature, and certifications.

Warranty

Three Year Limited Warranty

Outlines Delta Electronics' three-year limited warranty terms and conditions for ventilation fans.

Delta GBR80MHLED Specifications

General

Brand	Delta
Model	GBR80MHLED
Category	Ventilation
Language	English