To Next PageTo Next Page
Need help?Do you have a question about the Delta ShopMaster DBN125 and is the answer not in the manual?
Read and follow all warnings and operating instructions before using any tool or equipment.
Operator and others must wear safety glasses with side shields conforming to ANSI Z87.1.
Keep fingers away from trigger when not driving fasteners to avoid accidental firing.
Use clean, dry, regulated compressed air at 70 to 120 PSI.
Disconnect tool from air supply before maintenance, clearing jams, leaving work area, or moving the tool.
Only use parts, fasteners, and accessories approved by Delta Machinery.
Operator and bystanders should wear hard hats to safeguard against possible injuries.
Keep proper footing and balance; fire fasteners into work surface only, not hard materials.
Do not drive fasteners on top of others or near edges to avoid ricochet or splitting.
Do not use Contact Actuation Mode on scaffolds, ladders, or for tasks involving location changes.
Employers must ensure compliance with safety warnings and instructions in the manual.
Details for DBN125, DBS125, and DNS100 models regarding nail/staple types and loading.
Compact, lightweight tools with jam release, adjustable exhaust, depth adjustment, and more.
Operates on clean, dry, compressed air (70-120 PSI); preferred system includes filter, regulator, oiler.
Connect tool to air supply and insert approved fasteners with points down.
Adjust the deflector to direct exhaust air and debris away from the operator.
Grip tool firmly, position nose, depress safety, squeeze trigger to fire fastener.
Clean and inspect tool daily for proper operation of trigger and safety mechanism.
Control fastener depth with the adjustment knob; clockwise increases depth, counterclockwise decreases.
Use cushion to reduce marring; it can be removed and stored in the magazine.
Disconnect air, open magazine, remove fasteners, open guide plate, remove jammed fastener.
Wipe tool clean, inspect for wear/damage, check trigger/safety, tighten screws.
Only authorized Delta service stations or factory centers should perform repairs.
Covers air leaks, tool non-operation, frequent jamming, and solutions.
A complete line of accessories is available from authorized suppliers.
Details on repair or replacement for defective products within two years.
Lists US and Canadian Porter-Cable • Delta Service Centers for parts and repair.
General