Delta V3 - Fitting the Swing Check Valve and Socket (if Supplied but Not Fitted); Adjusting the Cut-In Level Control

CLICK!
STOP
CUT-INLEVEL
CUT-OUTLEVEL
Installation and operating manual Delta V3, V4, V6 Submersible Pump
5Installationatsite
5.3Fittingtheswingcheckvalveandsocket(ifsuppliedbutnottted)
 
 ¼"
 


1
3
2
 

 
5.4Adjustingthecut-inlevelcontrol
Figure 4. Switching levels.
Table 4. Cut-in levels and cut-out levels.
Pump set Factorysetting Maximumlimits
Cut-outlevel(mm) Cut-inlevel(mm) Cut-outlevel(mm) Cut-inlevel(mm)
    
    
    
