12 Descriptions of Parameter Settings | VFD-ED
38: ov (over-voltage) hardware error (Hd2)
39: GFF (ground fault) hardware error (Hd3)
40: Auto-tuning error on motor’s parameter (AuE)
41: Reserved
42: PG feedback error (PGF1)
43: PG feedback loss (PGF2)
44: PG feedback stall (PGF3)
45: PG slip error (PGF4)
46: Reserved
47: Reserved
48: Reserved
49: External fault input (EF)
50: Emergency stop from external terminals (EF1)
51: Reserved
52: Password error after three attempts (Pcod)
53: Reserved
54: Illegal communication command (cE01)
55: Illegal communication address (cE02)
56: Communication data length error (cE03)
57: Communication attempts to write to a read-only address (cE04)
58: Modbus transmission time-out (cE10)
59: Keypad transmission time-out (cP10)
60: Brake transistor error (BF)
61–63:
Reserved
64: Mechanical brake feedback error (MBF)
65: PG hardware error (PGF5)
66: Magnetic contactor error (MCF)
67: Motor output phase loss (MPHL)
68: CAN BUS disconnected (CANF)
69–71:
Reserved
72: Safe torque loss (STL1)
73: PG cd hardware error (PGcd)
74: PG absolute signal error (PGHL)
75: PG Z phase signal loss (PGAF)
76: Safe torque output stops (STO)
77: Safe torque loss 2 (STL2)
78: Safe torque loss 3 (STL3)
82: U-phase output phase loss (OPHL)
83: V-phase output phase loss (OPHL)
84: W-phase output phase loss (OPHL)
86: Leveling switch short-circuited (LSS)
87: Leveling switch open-circuited (LSo)
94: BTTx Fail (btt)
95: BTTx Error (bttE)
 The parameters record when the fault occurs and forces a stop. For the Lv, it records when it is operating,
or it warns without recording.
To Next Page
Loading...
Need help?
General