Chapter 7 Optional AccessoriesMS300
147
File type mismatch
(ERR8)
Data to be copied are not the correct type,
so the setting cannot be changed.
1. Check if the products’ serial
numbers to be copied are in the
same category. If they are in the
same category, try to copy the
setting again.
If this solution does not work, contact your
authorized dealer for assistance.
File is locked with
password
A setting cannot be changed because
some data are locked.
1. Check if the data are unlocked or
able to be unlocked. If the data are
unlocked, try to change the setting
again.
2. Shut down the system, wait for ten
minutes, and then restart the
system.
If none of the above solutions works,
contact your authorized dealer for
assistance.
A setting cannot be changed because the
password is incorrect.
1. Check if the password is correct. If
the password is correct, try to
change the setting again.
2. Shut down the system, wait for ten
minutes, and then restart the
system.
If none of the above solutions works,
contact your authorized dealer for
assistance.
A setting cannot be changed because the
version of the data is incorrect.
1. Check if the version of the data
matches the motor drive. If it
matches, try to change the setting
again.
If this solution does not work, contact your
authorized dealer for assistance.
AC motor drive copy
function time-out
A setting cannot be changed because the
data copying time-out expired.
1. Try copying the data again.
2. Check if copying data is authorized.
If it is authorized, try to copy the
data again.
3. Shut down the system, wait for ten
minutes, and then restart the
system.
If none of the above solutions works,
contact your authorized dealer for
assistance.
NOTE: The content in this section only applies to the KPC-CC01 keypad V1.01 and later versions..
To Next Page
Loading...