Delta VFD2A7MS43ANSAA

Chapter 12 Descriptions of Parameter SettingsMS300
421

09-76
Communication Card IP Address 1 (for EtherNet)

09-77
Communication Card IP Address 2 (for EtherNet)

09-78
Communication Card IP Address 3 (for EtherNet)

09-79
Communication Card IP Address 4 (for EtherNet)
Default: 0
Settings
0–255
 Use Pr.09-76–Pr.09-79 with a communication card.

09-80
Communication Card Address Mask 1 (for EtherNet)

09-81
Communication Card Address Mask 2 (for EtherNet)

09-82
Communication Card Address Mask 3 (for EtherNet)

09-83
Communication Card Address Mask 4 (for EtherNet)
Default: 0
Settings
0–255

09-84
Communication Card Gateway Address 1 (for EtherNet)

09-85
Communication Card Gateway Address 2 (for EtherNet)

09-86
Communication Card Gateway Address 3 (for EtherNet)

09-87
Communication Card Gateway Address 4 (for EtherNet)
Default: 0
Settings
0–255

09-88
Communication Card Password (Low Word) (for EtherNet)

09-89
Communication Card Password (High Word) (for EtherNet)
Default: 0
Settings
0–99

09-90
Reset Communication Card (for EtherNet)
Default: 0
Settings
0: Disable
1: Reset to defaults

09-91
Additional Settings for the Communication Card (for EtherNet)
Default: 0
Settings
bit 0: Enable IP filter
bit 1: Enable Internet parameters (1 bit)
When the IP address is set, this bit is enabled. After updating the
parameters for the communication card, this bit changes to disabled.
bit 2: Enable login password (1 bit)
When you enter the login password, this bit is enabled. After updating
the communication card parameters, this bit changes to disabled.