To Next PageTo Next Page
Need help?Do you have a question about the Delta ZURA Series and is the answer not in the manual?
General| Brand | Delta |
|---|---|
| Series | ZURA |
| Product Category | Plumbing Product |
| Material | Brass |
| Water Pressure | 80 PSI |
| Temperature | Up to 120°F |
| Warranty | Limited Lifetime |
| Finish | Chrome |
| Connection Size | 1/2 inch |
| Cartridge | Diamond Seal |
Place black valve anchors into sink holes and align them using the lift rod notches.
Tighten anchor screws until cleats contact the sink underside, then firmly secure them.
Install hot side valve assembly in the left hole, feeding tubes and nut through the anchor.
Tighten anchor nuts with a wrench and attach handle bases and handles to valve stems.
Install the spout, gasket, and connect the Y-connector and outlet tubing.
Addresses common installation problems like tubing cuts and provides remedies.
Flush supply lines with temporary lines to remove debris before final connection.
Connect 3/8" compression fittings, ensuring proper tightening without overtightening.
Cut PEX tubing straight and use provided sleeves and nuts for custom fit connections.
Detailed steps for correctly installing the plastic sleeve and nut on PEX tubing.
Visual guide to common mistakes in plastic sleeve installation for leak prevention.
Remove stopper, prepare tailpiece, apply silicone, insert body, and screw flange into place.
Secure the pop-up assembly, install lift rod components, and connect to the drain.
Instructions on how to change the handle stop position for correct handle operation.
Guidance on resolving issues like low water flow and leaks from the handle or spout.
Advice on cleaning the faucet gently with a damp cloth to maintain its finish.
Details on warranty coverage, exclusions, and the process for making claims.
A comprehensive list identifying all faucet components with their respective part numbers.
