Notsi, Ltd., Bulgaria, 9027 Varna, Troleyna 12 street
Ph.: 00359 899 822010 ; Fax: 00359 52 507227
Web: www.deltapulse.eu ; E-mail: sales@deltapulse.eu
Mole Impulse Pro operation manual
Mole Impulse PRO is professional metal detector, which is exceptionally
stable and efficient for a work over mineralized soil and at heavy ground
conditions. This professional detector is destined for deep situated treasures,
buried up from years valuables, cables, pipes, ammunition a others, while at the
same time throw off small metal objects.
CONTROL
Power – regulate the power of the device. At position 1 the power is minimal,
and at position 10 is maximal. In the most cases it is work at maximal power.
Gain – regulate the gain of the received from the device signal. In the most
cases it is work at position 10.
Threshold – threshold tone, in the most cases is at position 8-10, as for soils
with humidity above 65% must be above 8. This will be decided in dependency
from the situation by the operator.
Signal – eliminate the ground mineralization. In normal soil is at position
6-8, and at strong mineralization - at position 8-10 (very stable).
Noise – eliminate the influence of the ground mineralization in combination with
a signal. Usually it is at position 10.
Fast Zero – eliminate the ground mineralization and the detector choose the
most appropriate depth for the case. When the device is ready to work and the
coil is above the ground this button is pressed for about 3 seconds. When the
button is pressed, you must be sure that below the coil there is not metal object.
In the time of work is advisable this button to be pressed at every 3-5 minutes.
The metal-detector Mole Impulse is one from the most worldwide power
detectors operating at principle of pulse induction. The depth of penetration in
To Next Page
Loading...