Notsi, Ltd., Bulgaria, 9027 Varna, Troleyna 12 street
Ph.: 00359 899 822010 ; Fax: 00359 52 507227
Web: www.deltapulse.eu ; E-mail: sales@deltapulse.eu
Mole Impulse Pro operation manual
1. Lift up the coils at working height at 20 cm above the surface and press for 3
seconds FAST ZERO. Go forward and when you hear the first signal tone
mark with a flag the beginning of the signal at the coil front.
2. Continue the motion ahead. The signal tone will be constantly heard. Continue
to move until go off the signal. Cease the motion and put a flag at the coil rear
end.
3. Turn yourself to a 90 degrees and repeat operations 2 and 3.
4. Connect the two diagonals of this way received square and you will found the
center of the object.
If, at time of operation you are disturbed from brief sounds from small metal
objects on the surface, then you must lift up the coil to about 25 cm above the
ground, to press for 3 seconds FAST ZERO and to go forward.
ATTENTION
Do not work with the device when the LOW BATTERY lamp is on. If you go
on working with the lamp on you will use up the battery to such an extent, that
after this the charger will not accept it for charging, i.e. the battery will fall off
bellow its critical voltage.
BATTERY CHARGING
The charger’s output to be plugged in jack COIL. Insert the plug into the
contact 220V and on the front ON/OFF button will light up the permanent red
color LED indication. Please to switch on the ON/OFF button into position “ON”
and will begin to light the green light „CHARGE”. This will be the start of
To Next Page
Loading...