EN
Use with ozone
skimmers are suitable for use with ozone and will automatically suck the gas through the venturi hose. A maximum volume of 25 mg/h should be
used on tank volumes that are suitable for this skimmer. Do not use excessive ozone, as it is dangerous and can cause severe headaches.
Maintenance
The skimmer range should require very little adjustment and maintenance due to the high levels of calcium in marine aquariums and large volumes of
air drawn in, it is common for deposits to accumulate. Regular introduction of a small amount of RO water into the inlet tap whilst running may help to prevent
any build up of salt and debris in the venturi.
The MCE 600 is fitted with an Deltec pump, Deltec pumps are fitted with a little flap inside the outlet of the pump, which flips from one side to the other
depending on the direction of rotation thus ensuring that the pump always operates at full duty. This is illustrated on the attached drawing. It is recommended
every 3 months to strip down the pump to check and clean the impellor of debris. Ensure that the direction flap moves easily and if necessary soak the neck of
the pump housing in white vinegar or kettle scale remover.
Fault finding
Malfunction cause remedy
tap, airline or venturi blocked clean
airline kinked remove kink
ozonizer blocked clean
Pump produces
insufficient air
Pump flap No. 8a blocked clean
caused by additives in certain
sea salts and water conditions
use different salt or feed heavily for a
period, empty skimmer cup frequently,
open air tap fully. This condition may last
for several weeks.
excessive air bubbles in
aquarium water
air tap closed to far open air tap
Technical data
Dimensions
(l/w/h) app.
Power
consumption
Air flow app.
min. height for
sump installation
Aquarium size
normal stocking
Aquarium size
light stocking
MCE 600 260x85x500mm 10 Watt 400 ltr./h 575mm 500 ltr. 600 ltr.
To Next Page
Loading...
