DEMA TITAN II T-812-LL User Manual

I-1024
Rev. G-43816
Page 13 of 16
3/23/18
ALARM DELAY (5 seconds to 10 minutes)
02:00 mm:ss
FEED LIMIT (5 seconds to 10 minutes)
10:00 mm:ss
RETURN TO 
SYSTEM ACCESS
RECHARGE TIME (1 second to 5 minutes)
00:01 mm:ss
(Either DEAD CYCLES or DWELL TIME will display depending on weather DOOR or CONVEYOR was
selected earlier under MACHINE TYPE)
INITIAL CHARGE (1 second to 10 minutes)
00:15 mm:ss
CHARGE CLOCK (10 minutes to 16 hours)
01:00 hh:mm
(Everything in this block is displayed in Probeless Mode only. Otherwise continue below the block.)
RETURN TO 
SYSTEM ACCESS
RINSE SPEED
50 0 – 100%
RINSE DELAY
1 0 – 15s
RINSE LIMIT
-- 15 – 70s
RINSE LENGTH (The length of the rinse cycle for one rack.)
12 5- 75s
PROBELESS
PARAMETERS
1 0-10
DWELL TIME (Conveyor machine only.)
01:30 mm:ss
(Door machine onl
y
.)DEAD CYCLES
DETERGENT ALARM
INACTIVE
D
ETERGENT ALARM
A
CTIVE
D
ETERGENT ALARM
M
ANUAL
DETERGENT TYPE
LI
Q
UID
DETERGENT TYPE
DRY
N
ote: When detergent type is liquid, the alarm is active, and the control is set to probeless, use a DEMA
82.15.1 Low Level Probe connected to the probe input.
D
ET. ALARM CAL.
CAL CHEM ENTER
D
ET. ALARM CAL.
CAL WATER ENTER
DET. ALARM CAL.
CALIBRATING
DET. ALARM CAL.
CALIBRATIN
G
D
ET. ALARM CAL.
SUCCESSFUL
DET. ALARM CAL.
F
AILED
RINSE CONTROL
PARAMETERS

DEMA TITAN II T-812-LL Specifications

General

Brand	DEMA
Model	TITAN II T-812-LL
Category	Control Unit
Language	English