Why Demco Water Pump will not prime?
If your Demco Water Pump won't prime, possible causes include fouled valves (clean them), worn piston wipers (replace them), a plugged strainer (clean it), air being sucked into the suction line (repair the line), an air lock in the suction line (reroute the line), or a worn piston (replace it).
What to do if Demco Water Pump puts out too little?
If your Demco Water Pump isn't putting out enough, the issue might be due to several reasons: fouled valves (clean them), worn piston wipers (replace them), a plugged strainer (clean it), air being sucked into the suction line (repair the line), an air lock in the suction line (reroute the line), a worn piston (replace it), a broken valve spring (replace the valve), or an improper rate setting (check the calibration).
Why Demco Water Pump leaks oil?
If your Demco Water Pump is leaking oil, it could be due to a worn oil seal or O-ring (replace the seals), too much oil in the drive case (lower the oil level), or a torn gasket (replace the gasket).
What to do if Demco Water Pump puts out too much?
If your Demco Water Pump is putting out too much, it is likely due to an improper setting. Check the calibration to correct it.
What causes chemical leaks through Demco Water Pump after it has stopped?
If your Demco Water Pump leaks chemicals after stopping, this may be due to a broken valve spring (replace the valve) or fouled valves (clean the valves).
What to do if solution leaking from weep hole at bottom front of Demco Water Pump neck?
If you notice solution leaking from the weep hole at the bottom front of your Demco Water Pump neck, it may indicate worn stackpack glands (replace the stackpacks) or a worn piston rod (replace the rod).
Specifies hose sizes, routing, and filter requirements for optimal flow and preventing air traps.
Details how to attach the clutch throw-out arm bracket, connect the return spring, and set the connector.
A chart listing tire sizes and their corresponding loaded radius for calibration.
Checklist items to verify before starting spraying operations, covering nozzles, hoses, tank, controls, pump, frame.
Procedures for cleaning and storing the pump and sprayer after the application season.
General| Model | LIL'THUMPER |
|---|---|
| Category | Water Pump |
| Type | Trash Pump |
| Engine | Honda GX120 |
| Hose Size | 2 inches |
| Engine Power | 4 HP |
To Next Page