Demerbox DB2 User Manual

DB2
QUICKSTARt guide
ultimate outdoor bluetooth
®
speaker
CHARGING
first timeuse
Charge the DemerBox DB2 fully before using for the first time.
The light on the charger will turn from red to green when fully charged.
Charge Status
The five green LED lights on the DemerBox DB2 control panel show
the battery state of charge. When all five LEDs are lit up, it will have
approximately 40 hours of continuous play time.
Preserving Battery Life
For best long-term battery life, don’t leave the DemerBox DB2 plugged
in for extended periods after the battery is charged.
CHARGE
STUFF
CHARGE
DEMERBOX
AUDIO
IN
Using the DemerBox
Single Unit Mode
Turn on the DemerBox DB2 by pressing the Power
button . Find DemerBox under your device’s
Bluetooth
®
settings and select it.
Charging a Device Using the DB2
1. Plug a device into the USB charge out port on
the DB2.
2. Turn on the DemerBox DB2. Keep in mind, a DB2
battery will drain faster if you’re charging a device
from it.
Aux Cable
Plug one end of the AUX cable into the DemerBox DB2
and the other into the audio output of your device.
Volume Controls
You can control the volume two ways:
1. Use the volume controls on your device.
2. Use the UP/DOWN arrow buttons on
the front of the DemerBox. These only work in
Bluetooth mode.
Using In and Around Water or Sand
IMPORTANT: Your DemerBox is only waterproof and sealed when the port plug is
properly inserted!
To Insert the Port Plug
1. Unscrew the port plug from its holder inside the DB2. To do this, use
one hand to hold the port plug collar while using your other hand to turn
the wings.
2. Close the DB2 lid and latch it.
3. Insert the port plug into the port tube outside the DB2 until the
port plug is fully seated in the port hole. To do this, use one
hand to hold the port plug collar and turn the port plug wings
clockwise until the plug is secure in the port hole. A snug
fit is all you need.

Demerbox DB2 Specifications

General

Brand	Demerbox
Model	DB2
Category	Speakers
Language	English

Summary

CHARGING

First Time Use Charging

Instructions for fully charging the DemerBox DB2 before its initial use.

Charge Status Indicators

Explanation of the five green LED lights indicating battery charge level and play time.

Preserving Battery Life

Advice on maintaining long-term battery health by avoiding prolonged charging.

Using the DemerBox

Single Unit Mode Setup

Connects the DemerBox DB2 to a device via Bluetooth for single-speaker functionality.

Charging Devices from DB2

How to use the DB2's USB charge out port to power other devices.

Auxiliary Cable Connection

Instructions for connecting audio devices using a wired AUX cable.

Volume Control Options

Methods for adjusting volume, either on the connected device or the speaker itself.

Water and Sand Usage

Inserting the Port Plug

Detailed steps for correctly inserting the port plug to ensure waterproof sealing.

MULTI-cast Mode: Connecting Multiple Speakers

Enabling Multi-cast Mode

Step-by-step guide to enable and pair multiple DemerBox speakers together.

Exiting Multi-cast Mode

Instructions on how to disconnect paired speakers and return to single mode.

Multi-cast Volume Control

Explanation of how volume controls function when multiple speakers are paired.

Adding Additional Speakers

Guidance on how to add more speakers to an existing multi-cast connection.