DENAFRIPS ARCE - INSTALLATION & SAFETY INSTRUCTIONS

To Next Page

To Previous Page

1. INSTALLATION'&'SAFETY'INSTRUCTIONS'

This STREAMER is designed and built to provide trouble-free performance, but as with all

electronic devices it is necessary to observe a few precautions:

• Unpack the STREAMER carefully.

• Position the STREAMER on a stable, horizontal surface, i.e. sturdy rack.

• The STREAMER supports voltage 100-250VAC worldwide voltage by a voltage

selector. The voltage selector can be found at the bottom of the STREAMER. Switch

it to the correct voltage prior to powering it up, i.e. 115V for the US / 230V for the

EU.

• Please connect the AC power cord with earth(ground) pin unless it is absolutely

required to reduce hum from the ground loops of the connected devices.

• Always ensure that when disconnecting and reconnecting your audio equipment the

mains supply is turned off.

• Position the power cord and signal interconnects where they are not likely cause trip

and fall hazard.

• Do not use the STREAMER near water, or place water-filled containers on the

STREAMER. Entry of liquid into the STREAMER is hazardous and may cause electric

shock and/or fire hazard.

• Do not place the unit under direct sunlight or heat source.

• Do not remove any covers or try to gain access to the inside. There are no user

adjustments or fuses to change without qualification.

• Clean regularly with a damp soft cloth. Do not use any cleaning agents as it might

damage the surface finishing.

• The electronics in modern hi-fi equipment is complex and may, therefore, be

adversely affected or damaged by lightning. For protection of the audio system

during electrical storms, disconnect the mains plugs.