Handlebar components has been pre-assembled
1. Unscrew bolt and remove
cap, bolt, and sleeve.!Leave
all spacers in place.
2. Place stem on steerer tube and
tighten the bolt on top of stem to
secure stem to front of bike!
3. Place stem onto the head tube.
Align stem to the center position.
4. Tighten and Secure bolts
on bottom of stem
5. Add Top Cap to stem bolt 6. Upon final assembly, revisit
this step to confirm alignment
with stem and front wheel
Please tighten and secure all bolts
To Next Page
Loading...
