Denali D3 - Installing the D3 Fog Lights; Installing The Mounting Bracket; Installing The D3 Fog Light; Connecting The D3 Fog Light

1. Installing the D3 Fog Lights
1.1 - Installing The Mounting Bracket
This D3 Light Mounting Kit is a designed to replace the OEM fog lights for Jeep Wrangler
JK/JK and Jeep Gladiator JT. The D3 lights will plug directly into the OEM harness and
will be controlled from the original fog light switch.
Step One: The mounting bracket will be installed to the original hinge of the D3 pod.
Use the a 13mm wrench and the M8 hardware that was included with your light pod to
attach the bracket to the pod.
DENALIELECTRONICS.COM
1.2 - Installing The D3 Fog Light
Step Two: The OEM fog lights and brackets now need to be removed from the vehicle.
The OEM lights can be accessed from behind the front bumper depending on your exact
vehicle model, the plastic splash guard may need to be removed to access the lights.
Step Three: Once the OEM fog lights have been removed, the D3 lights can be installed
into the bumper, reversing the steps used to uninstall the OEM fog lights.
1.3 - Connecting The D3 Fog Light
Step Four: Once installed, use the provided wiring adapter (c or d) to connect the D3
light to the OEM wiring harness. Use the adapter which matches the OEM connector on
your vehicle.
D3 Pod
Mounting Bracket (a)
M8 Hardware
OEM Fog
Light Harness
Wiring
Adapter (c or d)
D3 Light
Connector
Mounting Bracket
Screw (b)