EasyManua.ls Logo

Denali POWERHUB2 User Manual

Denali POWERHUB2
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
ELC.00.30000
1 2 3 4 5 6
POWERHUB2
Kit Contents
Power Distribution Module
WARNING! When mounting electronics to the
front fender, forks, fairing, or handlebars, you must
turn the handlebars fully left and right and fully
compress & uncompress the suspension to ensure
the wires will not bind and have enough slack for
your motorcycle to operate properly.
PLEASE READ BEFORE INSTALLING
TWISTED THROTTLE products should be installed by a
qualified, experienced motorcycle technician. If you are
unsure of your ability to properly install a product, please
have the product installed by your local motorcycle
dealer. TWISTED THROTTLE takes no responsibility for
damages caused by improper installation.
Medium strength liquid thread-locker (i.e., "Locktite")
should be used to secure all screws, bolts, and nuts.
All screws, bolts, and nuts should be checked after
driving the first 30 miles (50 km) to ensure that all are
tightened to the proper torque.
All screws, bolts, and nuts, including all replacement
hardware provided by TWISTED THROTTLE should be
tightened to the torque specified in the OEM mainte-
nance manual for your motorcycle. If no torque
specifications are provided in the OEM maintenance
manual, the following torques may be used:
M5.........................................................3.5 ft-lbs (5 Nm)
M6.........................................................6.5 ft-lbs (9 Nm)
M8........................................................16 ft-lbs (22 Nm)
M10......................................................32 ft-lbs (43 Nm)
M12..................................................... 55 ft-lbs (75 Nm)
- 6 Mini ATC Fused circuits for a total of 30 amps
- Each circuit can be switched or unswitched
- Wiring harness included
- Adhesive Velcro included
.............................................................
Features:
Twisted Throttle LLC
570 Nooseneck Hill Rd
Exeter, RI 02822
Phone: 401.284.4200
Fax: 401.223.6954
www.twistedthrottle.com
Instruction Rev: 01
Power Hub
Qty.........................1
2
Ring Terminal
Qty.........................1
3
Posi-Tap
Qty........................2
1
4
Velcro
Qty..................1 Set
Kit Contents
DENALI
Question and Answer IconNeed help?

Do you have a question about the Denali POWERHUB2 and is the answer not in the manual?

Denali POWERHUB2 Specifications

General IconGeneral
BrandDenali
ModelPOWERHUB2
CategoryPower distribution unit
LanguageEnglish

Summary

DENALI PowerHub2 Kit Components

PowerHub2 Module

The central Power Distribution Module component included in the kit.

Installation Hardware

Includes Posi-Tap connector, ring terminals, and adhesive Velcro for mounting.

PowerHub2 Installation & Safety

Installation Best Practices

Guidance on professional installation, thread-locker use, and fastener checks for safety.

Torque Specifications

Recommended torque values for various bolt sizes (M5-M12) when OEM specs are unavailable.

DENALI PowerHub2 Wiring Guide

Connect PowerHub2 to Battery

Connect the red wire to the positive and black wire to the negative battery terminal.

Tap Switched Power Source

Use Posi-Tap to connect yellow wire to a switched +12V source on the motorcycle.

Connect Devices to PowerHub2

Connect device positive wire to output terminal and ground wire to ground bus terminal on the PowerHub2.

Wiring Diagram Overview

Visual representation of the PowerHub2 wiring connections for power and devices.