Need help?Do you have a question about the Denison Hydraulics Jupiter 900 and is the answer not in the manual?
General| Brand | Denison Hydraulics |
|---|---|
| Model | Jupiter 900 |
| Category | Controller |
| Language | English |
Details about the manufacturer and their address.
Product name and part number for identification.
Lists EMC and other product compliance standards.
Contextual information regarding product testing and compliance.
Lists USA and European contact details for inquiries.
Details specific improvements and changes made to the product.
Specifies the voltage and current requirements for the unit.
Lists available reference voltage outputs for system interfacing.
Details available remote input signal types and impedance.
Specifies the operational temperature limits for the device.
Describes the adjustable positive and negative ramp ranges.
Details the PWM output driver, frequency, and current limits.
Lists feedback input types and voltage levels.
Specifies the method for disabling input commands.
Explains the emergency stop input signal and its function.
Details the reverse command input for bidirectional operation.
Describes the soft stop input for controlled shutdown.
Explains the function of the Power, IA, IB, and Stop LEDs.
Details adjustments for ramp times, min/max currents.
Lists test points for input, output, and signal ground measurements.
Provides dimensions, connector type, and weight.
Lists pin assignments for the S20-14087 I/O connector.
Overview of the driver card's purpose and features.
Describes the driver card's use in open-loop control systems.
Details use of the driver card with an options card for closed-loop control.
Explains the PWM output stage and frequency settings.
Describes various input signal options like voltage, current, and auxiliary.
Details the adjustable positive and negative ramp ranges.
Explains on-board indicators, adjustments, and test points.
Covers emergency stop, soft stop, reverse command, and ramp-at-zero.
Explains how to use the driver with an options card for closed-loop control.
Guidelines for EMC compatibility, grounding, and power supply.
Step-by-step instructions for initial setup and calibration.
Diagram showing switch and jumper configurations for settings.
Block diagram for minimum circuit configuration.
Illustrates input connections for voltage sources and potentiometers.
Illustrates input connections for current loop signals.
Diagram showing open loop control for Gold Cup/World Cup pumps.
Block diagram for minimum circuit configuration.
Diagram for open-loop speed control with horsepower limiting.
Diagram for closed-loop speed control with feedforward.
Diagram for closed-loop speed control with feedforward and HP limiting.
Diagram for closed-loop speed control with PI control.
Diagram for closed-loop speed control with PI and HP limiting.
Lists international distributors by region and country.
To Next Page