Dennis FT430 - Page 3

3
FT & Super Six SP20001_REV_4
&HUWL¿FDWHRI&RQIRUPLW\
)LQH7XUI)7&\OLQGHUPRZHUVSRZHUHGE\+RQGD*;3HWURO(QJLQH
0DQXIDFWXUHU Howardson Ltd, Howardson Works, Kirk Langley, Derby, DE6 4NJ. UK
2ZQHURI7HFKQLFDO'RFXPHQW Mr I.D. Howard, Howardson Ltd, Howardson Works Kirk Langley, Derby, DE6 4NJ, UK
1RWL¿HG%RG\ AV Technology Ltd, AVTECH house, Arkle Avenue, Stanley Green Trading Estate, Handforth, Cheshire,
SK9 3RW, UK
I the under signed Declare that these machines:-
The reliability and quality of performance of the '(11,6)7 depends upon some simple care maintenance carried out
regularly. This manual has been prepared to allow the user to carry out all such work.
It is advisable to read the instructions carefully. Proper care and attention will enable the machine to give a continuous,
satisfactory, and reliable service. Failure to carry out regular lubrication and maintenance as outlined in this manual may
render any guarantee or warranty invalid.
,QWKHFDVHRIDQ\GLI¿FXOW\RULIIXUWKHULQIRUPDWLRQRUDGYLFHLVUHTXLUHGRXU6HUYLFH'HSDUWPHQWLVDOZD\VDW\RXUFDOO,Q
the interests of speed and accuracy of information please quote the serial numbers of the machine and engine when
making enquiries.
For the mower, this is to be found on a plate attached to the side frame. The engine number is stamped on either the
crank case or the gear casing facing towards the front of the machine. We suggest you write the numbers on the front
page of this book.
,QWURGXFWLRQ
6HULDO1XPEHUV
0$&+,1(6(5,$/180%(5
MAKE A NOTE OF THE SERIAL NUMBERS OF YOUR MACHINE & ENGINE AND ALWAYS
QUOTE THEM IN ANY COMMUNICATION WITH PERSONNEL AT DENNIS.
NOTE
(1*,1(6(5,$/180%(5
Model Cutting Width Power (Honda)
Measured Sound Power
Level
Guaranteed Sound
Power Level
Serial Number
FT 430 17” (430mm) GX120 91dB Lwa 94dB Lwa See Product ID range
FT 510 20” (510mm) GX160 95dB Lwa 98dB Lwa See Product ID range
FT 610 24” (610mm) GX160 95dB Lwa 98dB Lwa See Product ID range
7HVWHGDWHowardson Works test site September 2011
Complies with the applicable requirements of:-
- Machine Directive 2006/42/EC
- Noise Directive 2000/14/EC (Annex VI Procedure 1)
0DQDJLQJ'LUHFWRU
,DQ+RZDUG