EasyManuals Logo

Denon AVR-S740H User Manual

Denon AVR-S740H
272 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #184 background imageLoading...
Page #184 background image
Bass
Set subwoofer and LFE signal range playback.
o
Subwoofer Mode
Select low range signals to be reproduced by subwoofer.
LFE
(Default):
The low range signal of the channel set to
“Small” speaker size is added to the LFE
signal output from the subwoofer.
LFE+Main:
The low range signal of all channels is
added to the LFE signal output from the
subwoofer.
0
“Subwoofer Mode” can be set when “Speaker Config.” - “Subwoofer” on the
menu is set to other than “No”. (v p. 177)
0
Play music or a movie source and select the mode offering the strongest bass.
0
If “Speaker Config.” - “Front” and “Center” are set to “Large”, and “Subwoofer
Mode” is set to “LFE”, no sound may be output from the subwoofers,
depending on the input signal or selected sound mode. (v
p. 177)
Select “LFE+Main” if you want the bass signals to always be produced from
the subwoofer.
o
LPF for LFE
Set LFE signal playback range. Set this when you want to change the
playback frequency (low pass filter point) of the subwoofer.
80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 200 Hz / 250 Hz
(Default: 120 Hz)
Contents Connections Playback Settings Tips Appendix
184
Front panel Display Rear panel Remote Index

Other manuals for Denon AVR-S740H

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-S740H and is the answer not in the manual?

Denon AVR-S740H Specifications

General IconGeneral
Channels7.2
Power Output per Channel75 W (8 Ohms, 20 Hz - 20 kHz, 0.08% THD)
HDMI Inputs6
HDMI Outputs1
Dolby AtmosYes
DTS:XYes
BluetoothYes
Wi-FiYes
HEOS Multi-roomYes
4K Ultra HD Pass-throughYes
Power Output per Channel (6 Ohms)110 W (6 Ohms, 1 kHz, 0.7% THD)
4K/Ultra HD UpscalingYes
Phono InputYes
Dolby SupportDolby Atmos, Dolby TrueHD, Dolby Surround
Auto CalibrationAudyssey MultEQ
Input Sensitivity/Impedance200 mV / 47 kOhms
Signal-to-Noise Ratio98 dB (IHF-A weighted, Direct mode)
EthernetYes
USB PortYes (front)
AM/FM TunerYes
Supported Audio FormatsMP3, WMA, AAC, FLAC, ALAC, WAV, DSD
HDR SupportHDR10, HLG, Dolby Vision
Wireless AudioAirPlay 2
DTS SupportDTS:X, DTS-HD Master Audio
Zone AudioZone 2
Frequency Response10 Hz - 100 kHz (+1, -3 dB, Direct Mode)
Total Harmonic Distortion0.08% (20 Hz - 20 kHz)
Built-in DAC192 kHz / 24-bit

Related product manuals