Need help?Do you have a question about the Denon AVR-S510BT and is the answer not in the manual?
General| Channels | 5.2 |
|---|---|
| Power Output | 70 Watts per channel (8 ohms, 20 Hz - 20 kHz, 0.08% THD) |
| Frequency Response | 10 Hz - 100 kHz |
| Response Bandwidth | 10 Hz - 100 kHz |
| Total Harmonic Distortion | 0.08% |
| Signal-To-Noise Ratio | 98 dB |
| HDMI Inputs | 5 |
| HDMI Outputs | 1 |
| HDMI Pass-Through | Yes |
| HDMI Version | 2.0 |
| HDCP Version | 2.2 |
| Bluetooth | Yes |
| 4K Ultra HD Pass-through | Yes |
| Audio Decoding | Dolby TrueHD, DTS-HD Master Audio |
| Wi-Fi | No |
| Inputs | 5 HDMI, 2 digital optical, 2 analog |
| Outputs | 1 HDMI |
| Dimensions | 17.1 in x 12.6 in x 5.9 in |
| Amplifier Output Details | 5 channels |
Provides step-by-step setup instructions via TV screen.
Used to turn the unit on or switch it to standby mode.
Used to select the desired input source.
Adjusts the main volume level.
Used for connecting USB storage devices.
For connecting the sound calibration microphone.
For connecting devices with HDMI outputs (5 inputs, 1 output).
For connecting speakers to the unit.
Select the desired input source.
Turns the unit on or off.
Adjust the volume level up or down.
Positions front speakers equidistant from listening position and TV.
Positions center speaker between front speakers, near TV.
Positions surround speakers equidistant to sides of listening position.
Positions subwoofer conveniently near front speakers.
Illustrates typical placement for a 5.1 surround sound system.
Connection procedure for TVs equipped with an HDMI port.
Connection procedure for TVs lacking an HDMI port.
Connecting satellite or cable TV boxes.
Connecting optical disc players.
Connecting video devices and game consoles.
How to power the unit on and switch it to standby.
How to choose the active input for audio/video.
Methods for controlling the audio output level.
Detailed steps for turning the unit on.
Using the knob or buttons to select input.
Using volume buttons or the master volume knob.
Steps to connect and switch to USB input.
Navigating and playing files from USB storage.
Steps to start the pairing process from the unit.
Finding and selecting the AVR in the device's Bluetooth list.
Selecting the Bluetooth input source.
Initiating music playback from the connected device.
Detailed steps for pairing devices, including password entry.
Connect FM/AM antennas before tuning.
Switch input source to FM or AM.
How to recall pre-registered settings using Quick Select buttons.
How to set and save desired configurations to Quick Select buttons.
Settings for Auto Setup and Manual Setup of speakers.
Initiates basic installation and connection setup.
Steps for positioning the sound calibration microphone.
Settings for subwoofers during auto setup (Direct/Without Direct mode).
Initiates the measurement and provides cancellation steps.
Measures and sets distances from listening position to speakers.
Procedures to update the unit's firmware via USB.
Re-running "Auto Setup" after speaker changes.
Solutions for when the remote control does not work.
Solutions for when the unit's display is off.
Solutions for improperly displayed filenames on USB devices.
Solutions for Bluetooth connection and sound cut-off problems.
Operation required to connect Bluetooth devices.
To Next Page
