Denon AVR-S510BT User Manual

o
No sound comes out
Symptom Cause / Solution Page
No sound comes out of
speakers.
0
Check the connections for all devices. 22
0
Insert connection cables all the way in. －
0
Check that input connectors and output connectors are not reversely connected. －
0
Check cables for damage. －
0
Check that speaker cables are properly connected. Check that cable core wires come in contact with the
metal part on speaker terminals.
22
0
Securely tighten the speaker terminals. Check speaker terminals for looseness. 22
0
Check that a proper input source is selected.
37
0
Adjust the volume. 38
0
Cancel the mute mode. 38
0
Check the digital audio input connector setting.
76
0
Check the digital audio output setting on the connected device. On some devices, the digital audio output
is set to off by default.
－
0
When a headphone is plugged into the PHONES jack on the main unit, sound is not output from the
speaker terminal and SUBWOOFER connector.
12
No sound comes out when
using the DVI-D
connection.
0
When this unit is connected to a device equipped with a DVI-D connector, no sound is output. Make a
separate audio connection.
－
Contents Connections Playback Settings Tips Appendix
97
Front panel Display Rear panel Remote Index

Denon AVR-S510BT Specifications

General

Channels	5.2
Power Output	70 Watts per channel (8 ohms, 20 Hz - 20 kHz, 0.08% THD)
Frequency Response	10 Hz - 100 kHz
Response Bandwidth	10 Hz - 100 kHz
Total Harmonic Distortion	0.08%
Signal-To-Noise Ratio	98 dB
HDMI Inputs	5
HDMI Outputs	1
HDMI Pass-Through	Yes
HDMI Version	2.0
HDCP Version	2.2
Bluetooth	Yes
4K Ultra HD Pass-through	Yes
Audio Decoding	Dolby TrueHD, DTS-HD Master Audio
Wi-Fi	No
Inputs	5 HDMI, 2 digital optical, 2 analog
Outputs	1 HDMI
Dimensions	17.1 in x 12.6 in x 5.9 in
Amplifier Output Details	5 channels