EasyManuals Logo

Denon AVR-X1300W User Manual

Denon AVR-X1300W
275 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #183 background imageLoading...
Page #183 background image
Error messages
An error message is displayed if Audyssey
®
Setup could not be completed due to speaker placement, the measurement environment, etc. If an error
message is displayed, check the relevant items and perform the necessary measures. Be sure to turn off the power before checking speaker connections.
Examples Error details Measures
No speakers found.
0
Sound calibration microphone is not
detected.
0
Connect the included Sound calibration microphone to the
SETUP MIC jack of this unit.
0
Not all speakers could be detected.
0
Check the speaker connections.
Ambient noise is too high or level is too
low
0
There is too much noise in the room.
0
Either turn off any device generating noise or move it away.
0
Perform again when the surroundings are quieter.
0
Speaker or subwoofer sound is too low.
0
Check the speaker installation and the direction in which the
speakers are facing.
0
Adjust the subwoofer’s volume.
Front R : None
0
The displayed speaker could not be
detected.
0
Check the connections of the displayed speaker.
Front R : Phase
0
The displayed speaker is connected with the
polarity reversed.
0
Check the polarity of the displayed speaker.
0
For some speakers, this error message may be displayed
even if the speaker is properly connected. If you are sure the
connection is correct, press p to select “Ignore”, then press
ENTER.
Contents Connections Playback Settings Tips Appendix
183
Front panel Display Rear panel Remote Index

Other manuals for Denon AVR-X1300W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X1300W and is the answer not in the manual?

Denon AVR-X1300W Specifications

General IconGeneral
Display-
Product colorBlack
Audio decodersDSD, Dolby TrueHD
Audio amplifierYes
Multi-Zone quantity2
Apple docking compatibilityNot supported
Receiver typeSurround
Frequency range10 - 100000 Hz
Output impedance16 Ω
Input sensitivity200 mV
Audio output channels7.1 channels
Signal-to-Noise Ratio (SNR)98 dB
Power output per channel (20-20KHz@8 Ohm)145 W
Audio formats supportedAAC, AIFF, ALAC, FLAC, MP3, WAV, WMA
HDMI in6
Digital audio coaxial in0
Ethernet LAN (RJ-45) ports1
Supported video modes2160p
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.1 W
Power consumption (typical)430 W
AM band range522 - 1611 kHz
FM band range87.5 - 108 MHz
Supported radio bandsAM, FM
Connectivity technologyWired
Speakers connectivity type3.5mm
Optical drive includedNo
Weight and Dimensions IconWeight and Dimensions
Depth339 mm
Width434 mm
Height215 mm
Weight8500 g

Related product manuals