Denon AVR-X1800H User Manual

o
Height
Height speakers can be used with the Surround Back terminal.
n
Configuration
Set the speaker layout when installing 1 set (2-channels) of Height,
Ceiling or Dolby Atmos Enabled speakers.
The layouts that can be selected differ depending on the combinations
of “Amp Assign” and floor speaker settings in the menu. (“Amp
Assign” (v p. 189), “Front/Center/Surround/Surround
Back” (v p. 190))
[2-channel height speakers]
Height AUDIO OUT connector
No –
Front Height
Surround Back
Top Front
Top Middle
Front Dolby
Surround Dolby z
z
This can be selected when using Surround speakers. Set “Surround” in the menu
to “Yes”. (v p. 190)
o
Subwoofer
Set the presence of a subwoofer.
Yes
(Default):
Use a subwoofer.
No:
Select when a subwoofer is not
connected.
o
Bi-Amp
When “Amp Assign” is “5.1ch (Bi-Amp)”, the speaker terminal used for
the bi-amp connection of the front speakers is displayed. The terminal
is fixed to “SURROUND BACK”.
SURROUND BACK:
The SURROUND BACK speaker
terminal is used for the bi-amp
connection of the front speakers.
Contents Connections Playback Settings Tips Appendix
191
Front panel Display Rear panel Remote Index

Denon AVR-X1800H Specifications

General

Amplifier Channels	7.2
HDMI Version	2.1
HDCP Support	2.3
eARC	Yes
Dolby Atmos	Yes
DTS:X	Yes
Dolby Surround	Yes
DTS Neural:X	Yes
Bluetooth	Yes
AirPlay 2	Yes
HEOS Multi-Room	Yes
Input Sensitivity/Impedance	200 mV / 47 kohms
Supported Audio Formats	MP3, WMA, AAC, FLAC, ALAC, WAV, DSD
Power Output per Channel	80W (8 ohms, 20Hz - 20kHz, 0.08% THD)
HDMI Inputs	6
HDR Support	HDR10+, Dolby Vision, HLG
Wi-Fi	Yes
Phono Input	Yes
Frequency Response	10Hz - 100kHz
Total Harmonic Distortion	0.08%
Signal-to-Noise Ratio	98dB