Denon AVR-X2300W - Page 110

1. Version Display Mode
1.1. Actions
Version information is displayed when the device is started in this mode.
1.2. Starting up
While holding down buttons "
DIMMER
" and "
STATUS
" simultaneously, press the power button to turn
on the power.
then press the "
STATUS
" button to display the information in section 1.3 on the display.
b
The version list is also displayed on GUI while the version is displayed on the display.
1.3. Display Order
Error information (See "1.4. Error display") →
q
Model destination information →
w
Firmware Package
→
e
Main µ-com →
r
Main 1st Boot Loader →
t
DSP ROM →
y
Audio PLD →
u
GUI SFLASH →
i
Ethernet 1st Boot Loader, Hardware ID
→
o
Ethernet 2nd Boot Loader, Rhapsody Flag →
Q0
Ethernet IMAGE
→
Q1
Network MAC ADDRESS information →
Q2
Bluetooth MAC Address information
q
Model destination information :
AVR-S920W E3 *
AVR-X2300W \\\ *
\
： Region (E3, E2, E1C, JP)
w
Firmware Package :
Package :****
e
Main µ-com :
Main :%%%%####*
%
： Main version,
#
： Sub version
r
Main 1st Boot Loader :
Main FBL :**.**
t
DSP ROM :
DSP :**.**
y
Audio PLD :
Audio PLD:**.**
u
GUI SFLASH :
GUI :@@$\****
@
： Model code,
$
： Brand code (DENON=1),
\
： Region code (E3=1, E2=2, E1C=5, JP=4, ALL=0),
*
： version
i
Ethernet 1st Boot Loader, Hardware ID :
Ethernet FBL
Press "
STATUS
" button.
******-**
o
Ethernet 2nd Boot Loader, Rhapsody Flag :
Ethernet SBL
Press "
STATUS
" button.
B************-0A
Q0
Ethernet IMAGE :
Ethernet IMG
Press "
STATUS
" button.
I************
Q1
Network MAC ADDRESS information：
*NET MAC Address
Press "
STATUS
" button.
******-******
Q2
Bluetooth MAC ADDRESS information：
*BT MAC Address
Press "
STATUS
" button.
******-******
110
Caution in
servicing
Electrical Mechanical Repair Information Updating