EasyManuals Logo

Denon AVR-X3300W Manual

Denon AVR-X3300W
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Rod antennas for Bluetooth/wireless LAN
Stand this antenna upright when connecting to a network via wireless
LAN, or when connecting to a handheld device via Bluetooth.
REMOTE CONTROL jacks
Used to connect infrared receivers/transmitters in order to operate this
unit and external devices from a different room.
RS-232C connector
Used to connect home automation controller devices fitted with RS-232C
connectors. Consult the owner’s manual of the home automation
controller for more information about serial control of this unit.
Perform the operation below beforehand.
1. Turn on the power of this unit.
2. Turn off the power of this unit from the external controller.
3. Check that the unit is in the standby mode.
Video connectors (VIDEO)
Used to connect devices equipped with video connectors.
Connecting a set-top box
HOME
DISPLAY 2 REAR PANEL 2
The antenna clip can be removed from the rear panel.
A Rotate the antenna clip 90 degrees to the left.
B Pull the antenna clip out towards yourself.
The antenna clip is needed when transporting this unit. Keep it in a safe place.
Attach the antenna clip by following the steps for removing it in reverse.
Rear Panel (1 of 3)

Other manuals for Denon AVR-X3300W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X3300W and is the answer not in the manual?

Denon AVR-X3300W Specifications

General IconGeneral
Receiver typeSurround
Frequency range10 - 100000 Hz
Pre-out channels7.2
Pre-out connectivityYes
Audio output channels7.2 channels
Signal-to-Noise Ratio (SNR)100 dB
Total Harmonic Distortion (THD)0.05 %
Power output per channel (1KHz@6 Ohm)180 W
Power output per channel (20-20KHz@8 Ohm)105 W
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.1 W
Power consumption (typical)600 W
Product colorBlack
Audio decodersDTS-HD, DTS-HD Master Audio, Dolby TrueHD
Multi-Zone quantity2
Apple docking compatibility-
AM band range522 - 1611 kHz
FM band range87.5 - 108 MHz
Supported radio bandsAM, FM
HDMI in8
Audio (L/R) in5
Remote control in1
Composite video in3
Composite video out0
Connectivity technologyWired
Speakers connectivity typeClamp terminals
Audio formats supportedAAC, AIFF, ALAC, DSD, FLAC, MP3, WAV, WMA
Weight and Dimensions IconWeight and Dimensions
Depth389 mm
Width434 mm
Height167 mm
Weight10800 g

Related product manuals