Denon AVR-X3400H Owner's Manual

o
Connecting the speaker cables
Carefully check the left (L) and right (R) channels and + (red) and –
(black) polarities on the speakers being connected to this unit, and be
sure to connect the channels and polarities correctly.
1
Peel off about 3/8 inch (10 mm) of sheathing from the
tip of the speaker cable, then either twist the core wire
tightly or terminate it.
.
2
Turn the speaker terminal counterclockwise to loosen it.
.
3
Insert the speaker cable’s core wire to the hilt into the
speaker terminal.
.
4
Turn the speaker terminal clockwise to tighten it.
.
o
Connecting the subwoofer
Use a subwoofer cable to connect the subwoofer. Two subwoofers can
be connected to this unit.
To use two subwoofers, set “Subwoofer” to “2 spkrs” in the “Speaker
Config.” setting. (v p. 186)
The level and distance can be set separately for Subwoofer 1 and
Subwoofer 2.
.
SW1 SW2
Contents
Connections Playback Settings Tips Appendix
37
Front panel Display Rear panel Remote Index

Denon AVR-X3400H Specifications

General

Receiver type	Surround
Pre-out connectivity	Yes
Audio output channels	7.2 channels
Signal-to-Noise Ratio (SNR)	100 dB
Power output per channel (1KHz@6 Ohm)	135 W
Power output per channel (20-20KHz@8 Ohm)	105 W
HDCP version	2.2
Apple docking	No
Product color	Black
Audio decoders	DTS-HD Master Audio, DTS:X, Dolby Atmos, Dolby TrueHD
Audio formats supported	AAC, ALAC, FLAC, MP3, WAV, WMA
Supported radio bands	FM
Internet radio services supported	Deezer, Spotify, Tidal, TuneIn
HDMI in	8
Remote (IR) input	1
Composite video in	3
Component video (YPbPr/YCbCr) in	2
Multichannel audio output type	Terminals
Supported video modes	480i, 576i, 2160p
Connectivity technology	Wired & Wireless
Speakers connectivity type	Binding post
Certification	ISF
Power consumption (standby)	0.1 W
Power consumption (typical)	600 W

Weight and Dimensions

Depth	389 mm
Width	434 mm
Height	167 mm
Weight	10800 g