o
Speaker Virtualizer
The Speaker Virtualizer enhances the surround and height speaker
channels to create an enveloping virtual surround effect.
On
(Default):
Enables “Speaker Virtualizer”.
Off: Disables “Speaker Virtualizer”.
0
You can set this when the sound mode is “Dolby Atmos”, “Dolby Surround” or
sound mode that has “+Dolby Surround” in the sound mode name.
0
Usable when not using height, ceiling or Dolby Atmos Enabled speakers, or
when not using surround speakers.
0
Audio is not output from the surround back speaker if “Speaker Virtualizer” is
set to “On” when “Speaker Config.” - “Surr. Back” is set to “1 spkr” in the menu.
o
DTS Neural:X
DTS Neural:X Expands the non-object based audio signals and
optimizes them for your speaker configuration.
On
(Default):
Use “DTS Neural:X”.
Off: Do not use “DTS Neural:X”.
0
You can set this when sound mode is “DTS:X” or “DTS:X MSTR”.
o
IMAX
Sets the audio mode for IMAX playback.
Auto
(Default):
Automatically enables the IMAX mode
when IMAX content is detected.
On:
Enables IMAX settings for IMAX
streaming content when automatic
detection is not possible.
Off: Disables the IMAX mode.
0
In case of streaming the IMAX contents from online streaming service using
TV Apps or player Apps (such as Blu-ray player’s App), this unit may not
detect the signal as IMAX contents automatically. In this case, you can enable
IMAX mode by setting this parameter to “On” manually.
0
This setting can only be turned “On” when DTS 5.1 channel content recorded
as IMAX DTS is input.
0
This setting cannot be set when headphones are used.
Contents Connections Playback Settings Tips Appendix
173
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
