Name: Denon AVR-X3700H
Brand: Denon
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Connect the Sound calibration microphone to the

SETUP MIC jack of this unit.

When the Sound calibration microphone is

connected, the following screen is displayed.

Audyssey Setup

Dolby Speaker Setup

Channel Select

Amp Assign

Start

Your AV receiver can automatically measure the acoustics of

your room then optimize your speakers using the included

microphone and microphone stand.

Set the following items

if necessary.

Select “Start”, then press ENTER.

Audyssey

Setup can also make the following settings.

Amp Assign

The signals output from the HEIGHT1 and HEIGHT2 speaker

terminals can be switched in accordance with your speaker

environment. (“Amp Assign” (v p. 215))

Channel Select

If channels that are not to be used are set in advance,

measurement for the set channels is skipped, and measuring

time can be reduced. You can also change the number of

surround back speakers and subwoofer.

Dolby Speaker Setup

Set the distance between the Dolby Atmos Enabled speaker and

the ceiling.

This can be set when using the Front Dolby Atmos Enabled,

Surround Dolby Atmos Enabled or Back Dolby Atmos Enabled

speaker.

Follow the instructions on the screen display and press

“Next” to proceed further.

Contents Connections Playback Settings Tips Appendix

207

Front panel Display Rear panel Remote Index

Other manuals for Denon AVR-X3700H

Questions and Answers:

Need help?

Do you have a question about the Denon AVR-X3700H and is the answer not in the manual?

General