Denon AVR-X3800H User Manual

Changing the strength of Tactile
Transducer according to the input
source (Tactile Transducer)
Adjusts the volume of the tactile transducer output.
1
Press OPTION.
An option menu screen is displayed.
0
When the input source is “HEOS Music”, an option menu for
online music is displayed. Select “AVR Options…”, then press
ENTER.
2
Use cursor Up/Down to select “Tactile Transducer”,
then press ENTER.
The “Tactile Transducer” screen is displayed.
3
Use cursor Left/Right to set the tactile transducer
function to on/off.
On
(Default):
Enable tactile Transducer.
Off: Disable tactile Transducer.
4
If you selected “On” in step 3, press cursor Down and
adjust the “Level”.
5
Use cursor Left/Right to adjust the tone, then press
ENTER.
-12.0 dB – +12.0 dB (Default : 0.0 dB)
0
“Tactile Transducer” settings are stored for each input source.
0
This cannot be set when the “Speakers” - “Manual Setup” - “Tactile Transducer
Setup” - “Tactile Transducer” is set to “Disabled”.
Contents Connections Playback Settings Tips Appendix
121
Front panel Display Rear panel Remote Index

Denon AVR-X3800H Specifications

General

Channels	9.4
HDMI Outputs	3
Dolby Atmos	Yes
DTS:X	Yes
Wi-Fi	Yes
Bluetooth	Yes
HEOS Multi-room	Yes
Voice Control	Yes (Amazon Alexa, Google Assistant, Apple Siri)
eARC	Yes
Input Sensitivity/Impedance	200 mV / 47 kohms
Ethernet	Yes
Phono Input	Yes
AM/FM Tuner	Yes
Audyssey Room Correction	Audyssey MultEQ XT32
HDR Compatibility	HDR10+, Dolby Vision, HLG
Streaming	Spotify, Tidal
Frequency Response	10 Hz - 100 kHz (+1, -3 dB)
USB Port	Yes
Signal-to-Noise Ratio	100 dB (IHF-A weighted, Direct mode)