o
IMAX Audio Settings
You can configure special IMAX audio settings to recreate the
conditions of an IMAX theater.
Auto
(Default):
Applies the optimized speaker settings to
reproduce similar to the IMAX theater
environment.
Manual:
Manually adjusts the “High Pass Filter”,
“Low Pass Filter” and “Subwoofer
Output”.
0
You can set this when sound mode is “IMAX DTS” or “IMAX DTS:X”.
0
“Speakers” - “Crossovers”, “Bass” - “Subwoofer Output” and “LPF for LFE” in
the menu cannot be applied during IMAX playback.
o
High Pass Filter
Set the high pass filter cutoff frequency for all speakers during IMAX
playback.
40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz /
180 Hz / 200 Hz / 250 Hz (Default: 80 Hz)
0
You can set this when “IMAX Audio Settings” is set to “Manual”.
o
Low Pass Filter
Set the low pass filter cutoff frequency of the LFE signal during IMAX
playback.
80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 180 Hz /
200 Hz / 250 Hz (Default: 120 Hz)
0
You can set this when “IMAX Audio Settings” is set to “Manual”.
o
Subwoofer Output
Set the bass signal to be played by the subwoofer during IMAX
playback.
LFE + Main:
The low range signal of all speakers is
added to the LFE signal output from the
subwoofer. The LFE signal and the bass
component of each speaker is played.
LFE
(Default):
Only the LFE signal is played.
0
You can set this when “IMAX Audio Settings” is set to “Manual”.
Contents Connections Playback Settings Tips Appendix
166
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
