Explanatory Photos for DISASSEMBLY
• For the shooting direction of each photos used in this manual, see the photo below.
• A, B, C and D in the photo below indicate the shooting directions of photos.
• The photographs with no shooting direction indicated were taken from the top of the unit.
• Photos of AVR-X4400H E3 are used in this manual.
The viewpoint of each photograph
(Shooting direction : X) [View from the top]
Proceeding : TOP COVER → WiFi ANT
(1) Cut the wire clamps.
NOTE : ・Turn up and spare wire at position A.
↓Shooting direction: C↓
↑Shooting direction: D↑
↑Shooting direction: A↑
↓Shooting direction: B↓
1. WiFi ANT
↑Shooting direction: A↑
�
Proceeding : TOP COVER → FRONT ASSY
(1) Remove the screws.
(2) Remove the STYLE PINs and connectors. Remove the TAPE. Remove the FFC.
Cut the wire clamps. Remove the screws.
2. FRONT ASSY
View from the bottom
x6
↑Shooting direction: A↑
x2
FFC
FFC
CN321
CN602
Place the wire in this position.
CUT
STYLE PIN
STYLE PIN
TAPE
83
Caution in
servicing
Electrical Mechanical Repair Information Updating
To Next Page
Loading...
