Denon AVR-X4500H User Manual

Initializing registered preset codes
1
Press and hold down MAIN and OPTION until the DEV.,
TV and AVR indicators on the remote are flashing
green, then release.
Specifying the operating zone with the
remote control
To prevent accidental misuse, you can set the zone for which the remote
control unit is used.
1
Press and hold down either MAIN, Z2 or Z3 and SETUP
at the same time until the DEV., TV and AVR indicators
flash green.
MAIN: When only using MAIN ZONE
Z2: When using MAIN ZONE and ZONE2
Z3
(Default):
When using MAIN ZONE, ZONE2 and
ZONE3
Resetting the remote control unit
All the settings are restored to their defaults.
1
Press and hold down DEVICE MENU until the DEV., TV
and AVR indicators on the remote are flashing green,
then release.
2
Press 9, 8 and 1, in that order.
The DEV., TV and AVR indicators flash twice.
All the settings are restored to their defaults.
Contents Connections Playback Settings Tips Appendix
271
Front panel Display Rear panel Remote Index

Denon AVR-X4500H Specifications

General

Display	-
Quantity	1
HDCP version	2.2
Apple docking	No
Product color	Silver
Audio decoders	DTS:X, Dolby Atmos, Dolby Surround, Dolby TrueHD
Volume control	Rotary
Audio amplifier	Yes
Multi-Zone quantity	3
Connector contacts plating	Gold
Receiver type	Surround
Frequency range	10 - 100000 Hz
Audio output channels	9.2 channels
Signal-to-Noise Ratio (SNR)	100 dB
Power output per channel (20-20KHz@8 Ohm)	125 W
FM band range	87.5 - 108 MHz
Supported radio bands	AM, FM
Internet radio services supported	Amazon Music, Deezer, Napster, Pandora, SIRIUS Internet Radio, Spotify, Tidal, TuneIn, iHeartRadio
HDMI in	8
Audio (L/R) in	5
Composite video in	4
Component video (YPbPr/YCbCr) in	2
Connectivity technology	Wired
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.1 W
Power consumption (typical)	710 W

Weight and Dimensions

Depth	389 mm
Width	434 mm
Height	167 mm
Weight	13500 g