EasyManuals Logo

Denon AVR-X4500H User Manual

Denon AVR-X4500H
345 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #295 background imageLoading...
Page #295 background image
Resetting network settings
If network contents cannot be played or the unit cannot connect to the network, restarting the unit may improve the problem. We recommend restarting the
unit before returning the settings to the default settings. (v p. 275)
If the operations are not improved by restarting the unit, follow the steps below.
Network settings are reset to the factory default values. Make settings again.
However, the menu “Amp Assign”, “Speaker Config.” and “Video” settings are not reset.
.
SOURCE SELECT
p
DIMMER
X
1
Press X to turn on power to the unit.
2
Turn SOURCE SELECT to select “HEOS Music”.
3
Press and hold the main unit's DIMMER and p at the
same time for at least 3 seconds.
4
Remove your fingers from the two buttons when
“Network Reset...” appears on the display.
5
“Completed” is shown in the display when reset is
complete.
0
Before returning the settings to the default settings, use the “Save & Load” function
from the menu to save and restore the details of various settings configured on the
unit. (v p. 262)
0
You can also reset the network settings to the factory defaults using “Reset” -
“Network Settings” in the menu. (v p. 263)
NOTE
0
Do not turn the power off until reset is complete.
Contents Connections Playback Settings Tips Appendix
295
Front panel Display Rear panel Remote Index

Other manuals for Denon AVR-X4500H

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X4500H and is the answer not in the manual?

Denon AVR-X4500H Specifications

General IconGeneral
Display-
Quantity1
HDCP version2.2
Apple dockingNo
Product colorSilver
Audio decodersDTS:X, Dolby Atmos, Dolby Surround, Dolby TrueHD
Volume controlRotary
Audio amplifierYes
Multi-Zone quantity3
Connector contacts platingGold
Receiver typeSurround
Frequency range10 - 100000 Hz
Audio output channels9.2 channels
Signal-to-Noise Ratio (SNR)100 dB
Power output per channel (20-20KHz@8 Ohm)125 W
FM band range87.5 - 108 MHz
Supported radio bandsAM, FM
Internet radio services supportedAmazon Music, Deezer, Napster, Pandora, SIRIUS Internet Radio, Spotify, Tidal, TuneIn, iHeartRadio
HDMI in8
Audio (L/R) in5
Composite video in4
Component video (YPbPr/YCbCr) in2
Connectivity technologyWired
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.1 W
Power consumption (typical)710 W
Weight and Dimensions IconWeight and Dimensions
Depth389 mm
Width434 mm
Height167 mm
Weight13500 g

Related product manuals