EasyManuals Logo

Denon AVR-X4800H User Manual

Denon AVR-X4800H
339 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #254 background imageLoading...
Page #254 background image
On:
Power savings are always active,
regardless of volume or input signal.
Auto
(Default):
Gives you the best balance between
power savings and maximum power
output:
For low volume levels, the power savings
are active. If you increase the volume
level, the power savings are switched off
automatically, so you can enjoy
maximum output power without
distortion.
If the volume is set to a high level but no
input signal is detected for more than 2
minutes, this unit will enable power
savings. When an input signal is detected
again or the input source is changed, this
unit will automatically turn off power
savings again at high volume levels.
Off:
No power savings.
0
When the unit is switching between the different power saving states in “ECO
Mode: Auto”, you may notice a click noise from the inside of this unit, this is
normal.
0
If content is paused for more than 2 minutes and playback is resumed from the
same source at these high volume levels, there may be short delay before
maximum power is restored.
0
“ECO Mode” can also be switched by pressing ECO G on the remote control
unit.
Contents Connections Playback Settings Tips Appendix
254
Front panel Display Rear panel Remote Index

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X4800H and is the answer not in the manual?

Denon AVR-X4800H Specifications

General IconGeneral
Channels9.4
Dolby AtmosYes
DTS:XYes
HDMI Inputs7
HDMI Outputs3
4K/120Hz Pass-throughYes
8K SupportYes
Wi-FiYes (2.4GHz/5GHz)
BluetoothYes
HEOS Built-inYes
Amplifier Channels9
Power Output per Channel @ 8 Ohms / 1 kHz / 0.08% THD / 2 Channels Driven125W
Speaker Impedance4-16 Ohms
Auro 3DYes
IMAX EnhancedYes
HDCP Support2.3
HDR CompatibilityHDR10, HDR10+, Dolby Vision, HLG
eARC SupportYes
Phono InputYes
EthernetYes
Voice Assistant SupportAmazon Alexa, Google Assistant, Apple Siri
Audyssey MultEQ XT32Yes
Total Harmonic Distortion0.05%
Input Sensitivity/Impedance200 mV / 47 kOhms
Network ConnectivityEthernet, Wi-Fi
Supported Audio FormatsMP3, WMA, AAC, FLAC, ALAC, WAV, DSD
Dimensions (W x H x D)434 x 167 x 389 mm
Weight13.5 kg
Power Output per Channel125W
Voice ControlYes
Frequency Response10 Hz - 100 kHz
DAC32-bit AKM
Video Pass-Through8K
Zone Audio OutputZone 2, Zone 3
Wireless Audio StreamingYes
Signal-to-Noise Ratio102 dB
Video Inputs/Outputs7/3 (HDMI)
Audio Inputs/Outputs7 HDMI inputs, 3 HDMI outputs, 1 phono input, 2 optical inputs, 1 coaxial input

Related product manuals