EasyManuals Logo

Denon AVR-X4800H User Manual

Denon AVR-X4800H
339 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #300 background imageLoading...
Page #300 background image
Resetting network settings
If network contents cannot be played or the unit cannot connect to the network, restarting the unit may improve the problem. We recommend restarting the
unit before returning the settings to the default settings. (v p. 279)
If the operations are not improved by restarting the unit, follow the steps below.
Network settings are reset to the factory default values. Make settings again.
However, the menu “Amp Assign”, “Speaker Config.” and “Video” settings are not reset.
.
SOURCE SELECT
p
DIMMER
X
1
Press X to turn on power to the unit.
2
Turn SOURCE SELECT to select “HEOS Music”.
3
Press and hold the main unit's DIMMER and p at the
same time for at least 3 seconds.
4
Remove your fingers from the two buttons when
“Network Reset...” appears on the display.
5
“Completed” is shown in the display when reset is
complete.
0
Before returning the settings to the default settings, use the “Save & Load” function
from the menu to save and restore the details of various settings configured on the
unit. (v p. 266)
0
You can also reset the network settings to the factory defaults using “Reset” -
“Network Settings” in the menu. (v p. 267)
NOTE
0
Do not turn the power off until reset is complete.
Contents Connections Playback Settings Tips Appendix
300
Front panel Display Rear panel Remote Index

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X4800H and is the answer not in the manual?

Denon AVR-X4800H Specifications

General IconGeneral
Channels9.4
Dolby AtmosYes
DTS:XYes
HDMI Inputs7
HDMI Outputs3
4K/120Hz Pass-throughYes
8K SupportYes
Wi-FiYes (2.4GHz/5GHz)
BluetoothYes
HEOS Built-inYes
Amplifier Channels9
Power Output per Channel @ 8 Ohms / 1 kHz / 0.08% THD / 2 Channels Driven125W
Speaker Impedance4-16 Ohms
Auro 3DYes
IMAX EnhancedYes
HDCP Support2.3
HDR CompatibilityHDR10, HDR10+, Dolby Vision, HLG
eARC SupportYes
Phono InputYes
EthernetYes
Voice Assistant SupportAmazon Alexa, Google Assistant, Apple Siri
Audyssey MultEQ XT32Yes
Total Harmonic Distortion0.05%
Input Sensitivity/Impedance200 mV / 47 kOhms
Network ConnectivityEthernet, Wi-Fi
Supported Audio FormatsMP3, WMA, AAC, FLAC, ALAC, WAV, DSD
Dimensions (W x H x D)434 x 167 x 389 mm
Weight13.5 kg
Power Output per Channel125W
Voice ControlYes
Frequency Response10 Hz - 100 kHz
DAC32-bit AKM
Video Pass-Through8K
Zone Audio OutputZone 2, Zone 3
Wireless Audio StreamingYes
Signal-to-Noise Ratio102 dB
Video Inputs/Outputs7/3 (HDMI)
Audio Inputs/Outputs7 HDMI inputs, 3 HDMI outputs, 1 phono input, 2 optical inputs, 1 coaxial input

Related product manuals