No sound comes out of a specific speaker.
0
Check that speaker cables are properly connected.
0
Check that a selection other than “No” is set for the “Speaker Layout” setting in menu. (v p. 226)
0
Check the “Amp Assign” setting in the menu. (v p. 226)
0
When the sound mode is “Stereo”, audio is only output from the front speakers and subwoofer.
0
Audio is not output from the surround back speaker if “Speaker Virtualizer” is set to “On” when “Speaker Layout” - “Surround Back” is set to “1 spkr” in
the menu. (v p. 187)
0
When “Speaker Layout” - “Surround Back” is set to “2 spkrs”, “Speaker Layout” - “Center” is set to “Yes”, and sound mode is set to “IMAX DTS”,
surround audio is output from the surround back speaker. Audio is not output from the surround speaker. (v p. 228)
No sound is produced from subwoofer.
0
Check the subwoofer connections.
0
Turn on the subwoofer’s power.
0
Set “Speaker Layout” - “Subwoofers” in the menu to “1 spkr”, “2 spkrs”, “3 spkrs” or “4 spkrs”. (v p. 235)
0
When “Crossovers” - “Front” in the menu is set to “Full Range”, depending on the input signal and the sound mode, no sound may be output from the
subwoofer. (v p. 244)
0
When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the subwoofer. (v p. 246)
0
You can make the subwoofer always output sound by setting the “Subwoofer Output” to “LFE + Main”. (v p. 246)
DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”.
Contents
Connections Playback Settings Tips Appendix
287
Front panel Display Rear panel Remote Index
To Next Page
Loading...
