Denon D-60 - Page 22

Example: Setting the power to turn off in 30 minutes (remote contro! only)
Currently receiving
FM 87.50 MHz
Press the SLEEP
button.
Press the SLEEP
button 3 times
successively.
The original display
reappears after 5
seconds.
To cancel the sleep timer:
Press the SLEEP button repeatedly until the display reads “0”. The power turns off. Now press the POWER switch to turn the power
back on,
NOTES
e ifthe sleep timer is set to turn the power off before the timer off time, the sleep timer is given priority, and the power turns
REMOTE CONTROL UNIT
C—] Power
off when the sleep timer time is reached.
Do not press the TIMER STANDBY button after the power has been turned on with the timer. If this is done, the timer will
not function property.
FM 975 Qu
automono «= FLAT
NVA ANE,
AUTO MONO SLEEP
FRR ARN AIS
AUTO MONO.
FM
AUTO MONO
@ Ifthe same time is set for the on time and off time, the power will not turn on even if the standby indicator is on.
« {fthe timer is set for an AM or FM station and the timer on time is reached while listening to another station, the station
switches to the station which was set with the timer.
22
f3] RECORDING CASSETTE TAPES
DENON ctasons commonenr searemssrento cassitrt rare atce
Press the OPEN/CLOSE button for Deck 2 and
load the tape onto which you want to record.
Refer to Page 17.
Set the reverse mode selector,
Refer to Page 8.
Set the DOLBY NR selector.
Refer to Page 8.
T=] = y= [ soso
‘Oece ‘CuseeG COUNTER
met
2] @& sf)
@
Check
that
the
accidental
erasure
prevention
tabs
on
the
tape
onto
which
you
want
to
record
are
intact.
Recording
is
not
possible
if
the
accidental
erasure
prevention
tabs
are
broken
off.
Refer
to
Page
17.
@& OPEN/CLOSE 2 U
fe} )=—
emai
One-side recording
DOLBY NR
FF ON.
Press the receiver's band Press the receiver's FUNCTION button
selector button.
BAND
Select the station
you want to record.
and select PHONO or LINE.
FUNCTION
oO O
Sy <U
Start playback on the VDP or VCR.
cy
—__—_—_1__
{Recording starts)
Press the REC/REC MUTE button.
Press the play button (> or 4).
RR]
The recording indicator lights.
To stop recording, press the & button.
Two-side (reverse) recording
REV Lee
=—_
Set to the “ON” position to
record
Refer
‘
'
'
‘
t
in Dotby NR.
Set the disc in the
CD player.
to Page 13.
| Press the CD SRS button.
9°
CD SAS
; The recording indicator
lights and recording starts,
Operations marked fr} can also be performed using the remote control unit.