HEOS Amp QUICK START GUIDE
4
English
Français Español
STEP 3: CONNECT
OPTIONAL
If you are connecting the HEOS Amp to a wired network, connect the included Ethernet cable between the
HEOS Amp and your router. Do not connect the Ethernet cable if you are connecting your HEOS Amp to a
wireless network.
Connect the power cordConnect the speakers
b` q
1
2
A. Remove 3/8 inch (10 mm) of sheathing
from the tip of the speaker cable, then
either twist the bare wire tightly.
B. Turn the speaker terminal
counterclockwise to loosen it.
C. Insert the bare wire into the speaker
terminal.
D. Turn the speaker terminal clockwise to
tighten it.
HEOS Amp E3_QSG_2nd_0704.indd 4 2014/07/04 14:41:57
To Next Page
Loading...
